Problems setting up LBM

Hello,

I've been trying to get this up and running. I currently run windows 10. When I open the map I get the following error:
Unhandled exception has occured in your application. If you click Continue, the application will ignorethis error and attempt to continue. if you click quit, the application will close immediately.

Unable to load 'directxmap.dll": the specified module could not be found (exception from hresult: 0x8007007e)

Update:

Fixed initial problem. now trying to setup auto detect. when i click "capture sample of radar" nothing happens.

do you have vertical sync enabled? in game options ?

what did you do to fix first issue?

I have the same problem. Auto tab on the right is always red stripe
All settings are carried out according to the instructions.
Vertical sync enabled

Follow the steps in the auto tab

place radar in top left corner of the GAME window
sample
click the tip of the white radar resize arrow
click the tip of the resize arrow (on pixel level)
DONE

should be green then.





Edited 1 time(s). Last edit at 10/13/2016 03:53PM by Ido.

Hey Ido, I've followed the instructions, and I can see the lat,lon appear after following your steps, but the auto-follow on the lbm map screen is super flakey and updates sometimes once every 30 seconds. I've noticed I dont get that green confirmation bar (it stays red) after capturing the sample radar , any suggestions?

it works very poorly with small radar sizes, i would advise 50% and up of the radar scale.. also you can try putting a "note" under the radar window to reduce interference from lights and white ground with the readout.